(817) 416-8881

Kimark SMartFlare

Various SmartFlare Installations

  • Operates Without the Need for Fuel Gas
  • Gas Flow Measurement and Accumulation Is Standard
  • Interchangeable Flare Stacks
  • Modbus Communications
  • Control and Logging

 

Concept behind the Kimark SmartFlare

To burn VOC (Volatile Organic Compound) gases from condensate and water tanks using only the gas emitted by the vessels under normal operating conditions and eliminate venting of VOC gases into the atmosphere.

 

Go to www.smartflare.net

 

Operation of The Unit

By installing a low pressure sensor measured in ounces on the common manifold piping of the tank battery, the flare senses a rise in pressure and starts the burn sequence. With adjustable start and stop set points, the amount of PSI on the tanks and temperature of the burn can be controlled. An example would be: “ON” at six ounces and “OFF” at two ounces to keep the burn temperature at nominal.

 

Flame Detection

The standard unit is powered by 12 Volts DC, making solar charging an easy option for remote, or non powered applications. Other power combinations are also readily available.

 

Gas Flow Measurement

The ability to measure gas flow built into all of our SmartFlare Panels. Gas accumulation is measured in current rate, previous day, and previous hour increments.

 

Onboard Logging

The unit continually monitors temperature, pressure, and runtime. This is then logged to a two gigabyte memory chip which can be easily transferred to a computer and viewed as a standard .CSV file (Excel).

 

Features of the Kimark SmartFlare

  • The low profile of the enclosed flare and quiet running make it advantageous for use in both rural and populated areas.
  • The SmartFlare is designed to operate in multiple conditions. It can be a stand-alone controller at production vessels responding to fluctuation of gas vapors. In addition, it is a relief system for tank batteries with vapor recovery units that may not be able to handle unusual surges of gas.
  • Solar powered, eliminating the need for purchase power.
  • Low power fast acting electric motor actuator. This allows for opening and closing without the use of venting solenoids.
  • Built in Modbus communications for access through SCADA systems. The user can enter setup parameters from a simple, intuitive communication menu and be able to retrieve data within minutes.
  • Multi-State / Multi-Burner packages used for normal and high flow rate applications.

 

Sizes

Size of Outer Diameter — MCFGPD*

26" — 30

33" — 50

48" — 100

54" — 180

64" — 283

*MCFGPD rating based on specific gravity of 1.05 and a BTU of 1800. Different flow rates and pressures can be accommodated but will require a completed RFQ sheet.

 

experience + communication + innovation

= integration

© COPYRIGHT 2016 | ALL RIGHTS RESERVED

Kimark's Parent Company
Specializing in Vapor Recovery